TD-000218-00 revBILA Series Loudspeaker System User ManualWL2082-i full-range line array loudspeakerWL115-sw subwoofer line array loudspeakerFB20
10Rigging the Installation Line Array (continued)Attaching WL115-sw behind WL2082-i array using EB2082-iIt is sometimes necessary to suspend the subwo
11WL2082-i Controls and ConnectionsMODE Selection SwitchBI AMP: When set to BI AMP, an internal shading net-work removes the mid-frequencies from one
12WL115-sw ConnectionsInput ConnectionsThe WL115-sw input connectors are a pair of Neutrik NL8's wired in parallel. See Table 3 or the WL115-sw I
13WL2082-i SpecificationsFrequency Response: 80 - 20,000 Hz (+/- 3 dB)Frequency Range: 68 - 22,000 Hz (-10 dB)Maximum SPL (continuous/peak): HF: 126/1
14WL115-sw SpecificationsFrequency Response: 37 - 107 Hz (+/- 3 dB)Frequency Range: 35 - 112 Hz (-10 dB)Maximum SPL (continuous/peak): 124 dB/130 dBTr
15EB2082-i SpecificationsMaterial: Aluminum 6061-T6Finish: Black powder coat (White optional)Working Load Limit Information:FB2082-i SpecificationsMa
16PB2082-i SpecificationsMaterial Aluminum 6061-T6Finish Black powder coat (White optional)Working Load Limit Information:GS115-sw SpecificationsMate
17
18
2IMPORTANT SAFETY PRECAUTIONSInstall in accordance with QSC Audio Product's instructions and under the supervision of a licensed Professional Eng
QSC Audio Products, Inc. 1675 MacArthur Boulevard Costa Mesa, California 92626 USA©2006 “QSC” and the QSC logo are registered with the U.S. Pa
3IntroductionThe Installation Line Array (ILA) is a high performance line array system designed for the needs of Houses of Worship, Performing Arts fa
4Introduction (continued)WL115-swThe WL115-sw subwoofer extends the system’s low-frequency capability to 35 Hz. with a compact fourth-order bandpass e
5Figure 3: FB2082-i Array Frame1- Shackle holes (accept 3/4” (20 mm) screw pin anchor shackle)2- Center support bar3- Rigging plates4- Rigging plate r
6Rigging the Installation Line ArrayRules for Suspension •Correct use of all suspension hardware and components is imperative in sound system rigging
7Rigging the Installation Line Array (continued)1- Working Load Limits are per fastener loaded in double shear. Data is for informational purposes onl
8Rigging the Installation Line Array (continued)Pull-Back BarIf using the pull-back bar, attach to the bottom enclosure at the bot-tom-most splay angl
9Rigging the Installation Line Array (continued)3- Lower the array frame onto the enclosure, carefully aligning the rigging straps, and attach the top
Comments to this Manuals