27
RMX 850 RMX 1450 RMX1850HD RMX 2450
OUTPUT POWER
in watts
FTC: 20 Hz–20 kHz @ 0.1% THD, both channels driven
8 ohms per channel 185 260 350 450
4 ohms per channel 280 400 550 650
EIA: 1 kHz @ 0.1% THD, both channels driven
8 ohms per channel 200 280 360 500
4 ohms per channel 300 450 600 750
1 kHz @ 1% THD, typical, both channels driven
2 ohms per channel 430 700 900 1200
Bridge Mono:
8 ohms, 20 Hz–20 kHz, 0.1% THD 530 800 1100 1300
8 ohms, 1 kHz, 0.1% THD 600 900 1200 1500
4 ohms, 1 kHz, 1% THD, typical 830 1400 1800 2400
DYNAMIC HEADROOM 2 dB @ 4 ohms 2 dB @ 4 ohms 2 dB @ 4 ohms 2 dB @ 4 ohms
DISTORTION
SMPTE-IM < 0.01% < 0.01% < 0.02% < 0.02%
FREQUENCY RESPONSE20 Hz–20 kHz, +0/-1 dB
(at 10 dB below rated output power) -3 dB points: 5 Hz and 50 kHz -3 dB points: 5 Hz and 50 kHz -3 dB points: 5 Hz and 50 kHz -3 dB points: 5 Hz and 50 kHz
DAMPING FACTOR > 300 @ 8 ohms > 300 @ 8 ohms > 300 @ 8 ohms > 300 @ 8 ohms
NOISE (unweighted 20 Hz to 20 kHz, below rated output) 100 dB 100 dB 100 dB 100 dB
VOLTAGE GAIN 31.6× (30 dB) 40× (32 dB) 46x (33 dB) 50× (34 dB)
INPUT SENSITIVITY, V RMS
full rated power @ 8 ohms 1.15v (+3.4 dBu) 1.15v (+3.4 dBu) 1.16v (+3.5 dBu) 1.23v (+4.0 dBu)
INPUT IMPEDANCE (all models) 10K ohms unbalanced
20K ohms balanced
CONTROLS (all models) Front: AC switch, Ch. 1 and Ch. 2 gain
Rear: 10-position DIP switch
INDICATORS (all models) POWER: Green LED CLIP: Red LED, 1 per channel SIGNAL: Yellow LED, 1 per channel
CONNECTORS (all models) Input: Active balanced; XLR and ¼" (6.3 mm) TRS, tip and pin 2 positive, and barrier strip
Output: “Touch-Proof” binding posts and Neutrik Speakon™
COOLING (all models) Continuously variable speed fan, back-to-front air flow
AMPLIFIER PROTECTION (all models) Full short circuit, open circuit, thermal, ultrasonic, and RF protection
Stable into reactive or mismatched loads
SPECIFICATIONS SPÉ CIFICATIONS TECHNISCHE DATEN ESPECIFICACIONES
Comments to this Manuals